Contact Us at 800.338.8688

Model P3-RL Pneumatic Hot Stamp Press

Example Features

• Sturdy blanchard ground steel frame with convenient adjustable daylight and large aluminum work table for ease of mounting tooling
• Hardened linear shafts and maintenance free composite die set bearings guide heated head for precise stamping
• Dovetail die mounting plate
• Four corner die leveling adjustment
• Calibrated anti-pinch point die stroke adjustment
• Motor driven, timer controlled foil index system for precise advance of foil
• Operator friendly touch screen controls with totalizer counter, setup button, and head up delay
• Microprocessor controlled press functions
• Ten recipe storage for timer values, air pressure, and temperature settings
• Solid state, digital dual display proportioning heat control
• Two hand anti-tie down buttons with infrared sensing beams are ergonomically designed to eliminate physical pressure. Anti-pinch point and repeat circuits are designed for operator safety
• Anti-tie down and e-stop circuits are compliant with safety category 4 per ISO 13849-1 (EN954-1)
• Rugged steel tubing support frame

Special Features

• Inverted L frame design for customer specification. This press can be manufactured with regular frame design
• Versatile frame design allows this press to be upgraded from a one ton press to a two ton or three ton press by replacing the pneumatic cylinder. The convenient adjustable daylight and large aluminum work table make setup of tooling effortless.
• Microprocessor controlled press functions with touchscreen panel allows operator convenience and repeatable stamping. Standard features include head-up strip delay, totalizer cycle counter, and setup feature that allows the head to be jogged down.
• Four corner head leveling adjustment allows easy die alignment to stamping surface. Dies can be easily leveled to a particular part without the use of shims.
• Top quality components are utilized throughout the manufacturing of Hastings products. Electrical, mechanical, and pneumatic components are always standard off-the-shelf components that are readily available. All machined components are painted, nickel plated, or hard anodized for lasting protection.
• Pneumatic system utilizes high flow components to increase cycle time and efficiency. Pressure regulator and filter control the air flow to the Multi-Power® cylinder. The multi-stage cylinder generates high force from standard shop air without the need for toggle mechanisms and their inherent problems

Specifications

Model P3-RL
Maximum Stamping Pressure (tons)	3
Heated Platen Size (inches)	Imprint Size 8x8	Imprint Size 8x12	Imprint Size 8x16
Head stroke (inches)	0-3
Throat depth (inches)	7.5
Adjustable Daylight (inches)	0-16
Electrical requirements	220 VAC 11 Amps	240 VAC 16 Amps	240 VAC 21 Amps
Support Guide Rods with die set bearings	2	4	4
Approximate Dimensions
Maximum height (inches)	88 1/2
Width (inches)	49
Depth (inches)	36
Weight (pounds)	550